Custom 1911 work price list
CUSTOM 1911 SLIDE WORK PRICE LIST 2013
LABOR ONLY- I DO NOT SELL PARTS, YOU MUST SUPPLY YOUR OWN.
1
Machine fit slide to frame (carbon steel only)
90
2
Fit match barrel
150
3
:::: Hybrid barrels- Cut slide slot and fitting- Extra
70
4
Machine frame for Nowlin/Wilson/STI ramped barrel
100
5
Machine frame for Para/Clark ramped barrel
65
6
Fit Novak Rear Sight
90
7
Lighten Slide Rear Scallop (extra low-$85)
65
8
Machine slide cocking serrations (Colt style) Angled- $125
100
9
Reverse Plug Cut (Full shoulder). Flanged cut is $30.
50
10
Fit a standard racker, you supply racker- Brazos $90
60
11
Add a set screw to a racker
25
12
Add a ball and detent to a racker
50
13
Cut Dovetail and fit Front Sight ($10 extra to cut flat if needed)
60
14
Peen On Front Sight ($10 extra to cut flat if needed)
25
15
Three Side Top of Slide (tritop) Each stop, $15 extra, Comp $90 extra
150
16
Flat top slide
60
17
Machine slide and install BoMar BMCS/Clone (you supply the sight)
100
18
Lower Ejection Port
40
19
Flare Port
35
20
Fit Novak Rear Sight
90
21
Trigger Job (4-1/4 lb.) Series 70
60
22
::::  (4-1/2 lb.) Series 80
90
23
Competition Trigger Job (Parts Extra)
75
24
Fit Beavertail grip safety
75
25
Fit standard safety
40
26
Fit ambi safety
60
27
Flatten and serrate top of slide
180
28
Fit a barrel bushing ( you supply)
70
29
Fit and tune ejector (you supply)
30
30
Fit and tune extractor (you supply) Aftec style is $15 extra
30
31
Fit match trigger
30
32
Machine and fit SV trigger into STI frame
45
33
Chamber barrel
50
34
Machine STI style cocking serrations
75
35
Drill and tap frame for scope/sight mount
60
36
Barrel Ports each hole
45
37
Blend rear of slide to frame
20
38
Fit a compensator
 
a
Thread barrel for comp
45
b
Turn cone down to fit slide
25
c
Angle end of slide and set comp gap (.010-.015) Trubor barrels $20
extra
40
d
Machine bottom of comp for guide rod clearance
20
e
Chase threads on threaded barrel if comp will not fit properly
30
f
Contour top of comp to match slide ---Ribbed barrels $15 extra
35
g
Cut sides of comp to match slide
35
h
Align ream comp to bore
15
39
Blue gun
150
     
     
     
     
     
     
     
     
     
     
     
     
     
     
     
     
     
     
38- Fit Compensator- Depending on who's comp and your slide dimensions (they all
vary), some or all of the above may need to be done.
I do not recommend using stainless steel slides or frames when building a close
tolerance gun. They have a tendency to gall up. If you do, don't complain when it
does. You will have to send it out to get hard chromed.
CALIFORNIA RESIDENTS

Sorry, but I do not build guns or install compensators for residents
of California or any other state when there may be a problem with a
state or federal law. So don't send me anything or I will return your
parts at your cost.